Our pumps move corrosive, abrasive, and hazardous liquids safely and efficiently in chemical processing, water treatment, pharmaceuticals, and power plants. As an ISO 9001–certified manufacturer, we design, build, and support complete packages. Services include installation, commissioning, operator training, and after‑sales parts and technical help.
Key Advantages
✅Leakage control: Sealless magnetic coupling or engineered seals to minimize emissions and product loss.
✅Material fit: 304/316L stainless steels and optional engineered plastics/linings; elastomers such as EPDM or FKM selected for media and temperature.
✅Stable hydraulics: Predictable head–flow curves with attention to NPSH, viscosity, and temperature.
Mechanical reliability: Rigid shafts, heavy-duty bearings, and balanced impellers for continuous duty.
✅Verified quality: Every unit is tested before shipment under controlled procedures.
✅Efficient control: Optional variable-speed drive packages for energy savings and process stability.
Pump Types and Uses
Magnetic Drive Pumps (CQ series)
✅Sealless design removes shaft seals and helps prevent fugitive emissions. Well suited to toxic, volatile, or corrosive liquids.
✅Compact close-coupled layout simplifies installation. Corrosion-resistant materials available.
✅Typical duties: process transfer lines, tank unloading, and recirculation loops with low to medium flow at moderate heads.
Submerged Vertical Models (FYS)
✅Pump body operates below the mounting plate, so no priming is needed and vapor lock is reduced in tanks or pits.
✅Robust columns and wear components support continuous operation in aggressive media.
✅Typical duties: sumps, reactors, and storage tank discharge to downstream equipment or filters.
Stainless Steel Vertical Multistage Units (CDLF/GDL)
✅High head in a small footprint for clean or mildly corrosive chemicals, solvents, and process water.
✅Suitable for filtration skids, CIP lines, and heat exchanger circulation. Available with 304/316L wet ends and VFD control to hold setpoint pressure.
Materials and Sealing
Proper wetted materials extend service life. We supply 304/316L stainless steels and, where applicable, engineered plastics or linings. Seal faces and elastomers are matched to chemical composition, temperature, solids load, and vapor pressure. Our team also advises on derating for viscosity and temperature.
Controls and System Packages
Single‑pump variable‑speed control helps modulate flow or pressure, reduce energy use, and protect against cavitation or dry run. Packages can include baseplates, sensors, and interlocks for leak detection and tank level control.
Applications
✅Reactor feed and transfer between unit operations
✅Filtration loop circulation and heat exchanger service
✅CIP chemical delivery
✅Neutralization and utilities in water treatment
Selection Guide
✅Define media and conditions: concentration, temperature, viscosity, solids, vapor pressure.
✅Choose sealless vs sealed: use mag‑drive units for hazardous or volatile media; sealed options where suitable.
✅Integrate controls: apply VFDs for precise flow/pressure, energy savings, and protection.
FAQ
When should I choose a magnetic drive unit?
When handling toxic, volatile, or highly corrosive liquids where leak prevention and emission control are priorities.
What materials are available for wetted parts?
304/316L stainless steels are standard, with engineered plastics or linings upon request. Elastomers such as EPDM or FKM are selected for chemical and temperature compatibility.
Do you provide installation and commissioning?
Yes. We can install and commission the equipment, train operators, and supply spare parts and technical support.
Contact Chemical Pump Manufacturer
Share your medium, temperature, viscosity, and duty point. We will provide a fast selection with recommended materials, hydraulics, and control options tailored to your process.
